Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: michaelthomas on January 01, 2011, 10:42:39 AM
-
I just bought some 203V drives fro my new router. After reading about it's micro to full step morphing, I wondered if a higher top speed could be achieved without the need to raise the kernel speed.
I will be using 4032 steps per inch, and at a kernel speed of 45000.....I would top out at 669 IPM. Would that increase using the 203v's ?
-
No, the step morphing is completely transparent to the CNC controller.
Regards,
Ray L.
-
Thank you!