Machsupport Forum
Third party software and hardware support forums. => Newfangled Solutions Mach3 Wizards => Topic started by: Vmax on January 22, 2006, 11:58:05 AM
-
Brian on the tapping wizzard instead of a tool holder table( linked to Excel) we just need a place to put in the toolholder we are going to use. We should already know what the tool number we have set up in Mach is ( Or at least we should)and all the applied offsets are already set up. Program just has to use the correct tool number.
(:~)= Terry
-
I need to get a holder for running the tap :( After I have that I will get the tapping finished...
-
Brian you can look at Enco 2006 Master catalog page 298 or page 310. Or you can simply make one for testing. Look on the Yahoo mach site I outlined it for you, if you need to build one. I can send a print if needed. Heck I can build you one if that is all you need. (:~)= Terry
-
I can build one but I don't have the time :(
I am going to have to start looking on Ebay for the holder