Machsupport Forum
Third party software and hardware support forums. => PoKeys => Topic started by: M250cnc on December 28, 2010, 01:44:49 PM
-
In the popendant pdf pin 5 says connect to N.C.
What pin is that please.
Phil
Sent from my HTC Desire using Tapatalk
-
Hi!
Writing user manuals is very time consumpting work. To be honest nobody like these work, but we are writing them to help customers.
So, please READ USER MANUAL. It is not very hard and we put a lot of efforts in them.
In the same table at the bottom line, you have explanation for these: "NC.= not connected"
Simple?
regards
Boris
-
Boris thanks for your answer.
Lamps normally have two wires connected, hence my question.
Better be safe than sorry.
Phil
Sent from my HTC Desire using Tapatalk