Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: kencor1 on December 09, 2010, 12:11:21 PM
-
I am have an issue with mach going into e-stop when I load a long program. I am using the current development version with the machstd screen set. I am also using a smooth stepper. It only seems to happen on the long programs. Is there something that I should look for that could be triggering the e-stop?
Thanks,
Tom
-
If the "Use Watchdogs" is set in "General Configuration", loading or Regen-ing, can sometimes trip the "Driver watchdog" causing a e-stop... (At least on the laptop I use to cut with)
Marsha
-
Interested in the outcome of this one because I had a similar problem with very long programs (in excess of 340,000 lines of code).
Tweakie.
-
Another thing that might help is if you disable the toolpath view.
Hood
-
Thanks for the help. It seems that as long as I have the toolpath view unselected when I load or redrawing, the e-stop won't be triggered. If I have it enabled then the e-stop is triggered. Does anyone know if in Mach 4 if this will be fixed?
Thanks,
Tom
-
Yes it should be, everything will be in separate modules so problems like this shouldnt happen.
Hood