Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: duritskiy on November 30, 2010, 03:54:03 PM
-
macropump does not work in new versions MACH3.
why?
-
It does for me, check you have it enabled and have it in the correct macro folder.
Hood
-
I've found that I have to enable the macro pump twice to get it to stick. First time I enable it, exit Mach then restart, I find that the macro pump in general config is still disabled. If I enable it again, exit and restart, it stays enabled and the macro pump works.