Machsupport Forum
Mach Discussion => FAQs => Topic started by: Igloomason on November 14, 2010, 08:07:26 PM
-
My machine was working fine with Mach3 prior to some fumbling with the software. Now I am seeing all black on the LEDs on the Diagnosis page. I have reverted to a Port/Pin configuration that has been known to work, the breakout board appears to be functioning and is responsive to limit switches and when I disconnect the parallel port. A total reinstall of Mach3 makes some Pin LEDs green but I still have no control. Jog mode is currently and permanently off. What should I try?