Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: kocher on November 14, 2010, 04:42:05 PM
-
hi, can anyone help please all my g code start with G00 Y -40 even when iam try to wrihe small name within 2 cm square ? why gcode go too big G00 Y -40, thank you
-
What writes your code for you?
-
thanks for reply i typed letter in artcam and try to make small name necklace and transfer to gcode through artcam and put in mach3 i became very big G00 Y -40 .
-
Looks like your drawing in ArtCAM may be too big, either that or you need to do some scaling. Afraid I am not familiar with ArtCAM so cant really advise :(
Hood
-
If the G00 Y-40 is the first move in the G-code, then it sounds like your part is set up in ArtCam 40 units on the Y axis from zero origin. If that's the case, when you zero the DRO's in Mach and run the part, then the first move would be a rapid move to where the part is oriented in ArtCam.
-
you are using the wrong post processor if that's the first line of code output.
Which post are you selecting in ArtCam
-
thanks for your answers i got problem after i put the name into toolpath coz the letter abit small its me i dont know how to chose right tool i will learn but i need more information thanks