Machsupport Forum
Third party software and hardware support forums. => Third party software and hardware support forums. => Topic started by: ex apprentice on November 14, 2010, 04:30:16 PM
-
Hi all
I am in the process of building my table and thought I would ask this question.
Can anyone tell me the best bit of kit to work with Mach 3, Sheetcam & a floating Z axis to control the torch height?
I have read many bits and bobs about various bits of kit that work and don't work, I am looking for something reliable, does what it says on the box and cost effective.
simple to set up and install.
Or is this the holy grail??
Really looking forward to some guidance, thank you in anticipation for some positive feed back
Ex Apprentice
-
CandCNC hands down the best out there. Plug and play. At least it was here(;-).
(;-) TP