Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: kocher on November 11, 2010, 11:21:46 AM

Title: Feedrate 300% red
Post by: kocher on November 11, 2010, 11:21:46 AM

Hi is there any problem if put my machine feedrate 300% red is flashing  when is working I only engraving names 2mm thik silver ? Many Thanks

Title: Re: Feedrate 300% red
Post by: Hood on November 11, 2010, 11:25:03 AM

The red LED is flashing so that you know you have the feedrate over ridden, so no problems..
Hood

Title: Re: Feedrate 300% red
Post by: BR549 on November 11, 2010, 11:26:27 AM

Just a s a general rule IF you need to make that much adjustment I would reset the feedrates in the Gcode program to the proper level. Then use FRO to make MINOR adjustments.

Just a thought, (;-) TP

Title: Re: Feedrate 300% red
Post by: kocher on November 11, 2010, 11:33:06 AM

Thanks hood and active member .