Machsupport Forum

Mach Discussion => VB and the development of wizards => Topic started by: KB7CGA on November 09, 2010, 10:44:12 PM

Title: How to change axis direction in hoss auto probe od script?
Post by: KB7CGA on November 09, 2010, 10:44:12 PM

How to change axis direction in hoss auto probe od script?

As the script starts, I start just above the center of the part less than 0.5 inch.
the tool moves to the left, Z axis drop -.5 inch, then moves farther left away form the part,
insted of right into the part to touch. Normal MaxNC 10's home to the left, my home switch
( modified ) homes to the right. So under homing and limits, it is checked for reversed axis as
needed for my setup.

Title: Re: How to change axis direction in hoss auto probe od script?
Post by: BR549 on November 24, 2010, 08:45:26 PM

DID you get this sorted out??? Or do you still need help?

(;-) TP