Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: manising82 on October 22, 2010, 03:51:12 AM
-
hi im new to MACH 3 controller users , i neet to knoe if i purchase the controller for plasma & oxy cutting machine i can directly use the controller or i need to do any modifications in contriller ?
and what are the modifications need to be done ,step by step procedures ,please
which controller is suitable for plasma and oxy cutting machine LASY CAM /MACH 3
-
Hi,
It is not necessary to make multiple postings of the same subject on this forum. In fact it probably has the reverse effect to what you require.
Tweakie.
-
Without knowing the hardware you have/intend to use its impossible to say how much work would be involved in wiring them up to Mach.
If they are Step/Dir drives then it will be easy enough, if they are analogue then you would need to use something like DSPMC, Galil or K-Flop.
Hood