Machsupport Forum

Mach Discussion => FAQs => Topic started by: DonFrambach on October 16, 2010, 01:32:32 PM

Title: Changing stepper motor direction
Post by: DonFrambach on October 16, 2010, 01:32:32 PM

Extreme Newbie here.  Just connected my Z axis and it runs fine except it is reversed.  When I specify an up move it goes down and when I specify down, it goes up.
I swear I have read the fine manual but I can't find how to reverse stepper motor direction.
Would one of you kind souls please enlighten me?
Thanks.
Don Frambach

Title: Re: Changing stepper motor direction
Post by: Greolt on October 16, 2010, 04:11:26 PM

Menu, Config, Homing and Limits, check Reversed.

Greg

Title: Re: Changing stepper motor direction
Post by: DonFrambach on October 16, 2010, 04:35:12 PM

Thank you very much!