Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: chrispol on October 30, 2006, 07:18:45 PM
-
Anyone run mach 4 with a geko grex in production? looking to change my drive system from steppers to servo with geko's and a grex
-
Hi, Chrispol
Mach4 is now Mach3 with plug-in code, I don't think it's quite there yet, other's have more info.
Hope this Helps, Chip
-
I would not do it at this point :( But give it about 8 weeks and I think we may have something :)