Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: sircolin on October 11, 2010, 05:33:15 PM
-
hi everyone
I cannot zero the machine co-ordinates individually on x y & z on the mill can only zero them by clicking ref all home is this correct? or have I set something wrong,
on the lathe I can zero the machine co-ordinates individually
many thanks if you can help
Colin
-
You can if you go to the Diagnostics page as you can ref each axis individually. You could of course modify your screen to have the buttons on the main page if you wished ;)
Hood
-
thanks for that hood
dont think I am good enough to move buttons yet
but suppose will get there one day
Colin
-
Easy enough to do with one of the screen editors, you dont actually have to move, you can just add.
Hood