Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: MHJ on October 08, 2010, 06:29:37 AM
-
Hello.
whenever I load up the Turn Wizards I get the scrolling message "Fillet Radius is too big" .... and this message appears in every turn wizard!
Closing and restarting mach3 and/ or the computer makes no difference.
All the wizards have zero in every box....the message is still there. How do I get rid of the message?
XML attached,
Regards
John.
-
Just tried with your xml and its fine. What are you putting in as the fillet radius in the wizards?
Hood
-
Actually just reread and you say you have zero in each box, you need to enter numbers for the wizards to give you code.
Hood
-
Thanks, Hood.
I now know what I've done wrong, entered +ve values in the X and Z endpoints instead of -ve. Silly me. Plenty to learn eh?
Regards,
John.
PS. how are you on PWM signals from Mach3 to control the lathe spindle via a Homann Digispeed and an Emerson VFD?
-
Not a clue I am afraid, only ever had servo spindles.
Hood