Machsupport Forum
Third party software and hardware support forums. => dspMC/IP Motion Controller => Topic started by: TOTALLYRC on October 04, 2010, 02:57:54 PM
-
Hi Guys,
I just tried out the new plugin that allows tuning the motors from inside Mach3.
http://www.vitalsystem.com/web/motion/dspmc.php (http://www.vitalsystem.com/web/motion/dspmc.php)
Near the bottom of the page.
Very nice.
I like the fact that it honors the e-stop, home, and limit switches. This make it great to tune or re-tune the motors after they are connected to the load.
Mike