Machsupport Forum
Third party software and hardware support forums. => Newfangled Solutions Mach3 Wizards => Topic started by: titchener on January 19, 2006, 06:15:42 PM
-
Brian-
I has posted this a while back in the Yahoo mach forum, but the forum was really busy then and it might have slipped by you, I didn't see a response.
(originally posted on Yahoo mach forum)
Brian-
When using the Surfacing Material Wizard, the starting point for me is
always the upper left hand corner of the defined material, independent
of the selection I make for Start Position.
By the way, thanks for upgrade that automatically calculates chip load
based on the tool properties.
Paul T.
-
Yea it is going to start in the same place every time:( The points are to change where the X0 Y0 is not the start point.
Hope that helps, and I am sorry I didn't see the message
-
> The points are to change where the X0 Y0 is not the start point.
Whoops, a senior moment on my part, that makes more sense.
Paul T.