Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: hightechkey on September 28, 2010, 10:17:36 AM

Title: step feed rate in jog mode
Post by: hightechkey on September 28, 2010, 10:17:36 AM

Dear Sir

Mach3 has 'step' and 'continuous' in jog mode. Continuous jog speed can control with job slow rate setting. How can I control 'step' jog speed? The feed rate for step job is 6 mm per minute. It is very slow for me. I want to change the feed rate in step mode while jogging. How can I change? Please help me...

Best regards,

High Tech Key

Title: Re: step feed rate in jog mode
Post by: hightechkey on September 28, 2010, 10:35:27 AM

Dear Sir

Now I can change this feed rate. It is working with default feed rate. My mach3 default feed rate is 6mm per minute. How can I change my default feed rate? I want to set my default feed rate about 500mm per min. I mean I want to have 500 mm per min when my machine is start.

High Tech Key

Title: Re: step feed rate in jog mode
Post by: Hood on September 28, 2010, 11:17:59 AM

General Config page and put F500 in the initialisation string box.
Hood