Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: TOMMYD on September 26, 2010, 09:25:28 PM
-
I downloaded license to mach3 folder on 2ND computer but it is still running in demo mode.I am running a second computer and monitor to display encoders . The encoders are on the stepper motors which are closed loop between the motors and drivers. Will encoders show up for display even in demo mode? I will also use this computer for a back up and I am concerned that I can't retrieve the license agreement if something happened to the 1st computer. Thanks,Tommy
-
The licence is called Mach1Lic.dat and it needs to be placed in the main Mach3 folder, so check it is there and not in a sub folder.
Hood
-
Hood, Thats all it was.Thanks again,Tommy
-
No problem :)
Hood
-
And remember, if you are using your machines to generate a profit then you need to have one license per computer/machine pair.
-
I have 1 machine but am useing a 2nd computer to display encoders?
-
Thats fine, you can have Mach on as many computers as you like, if you are making money from the machines then you need a licence for each machine )lathe, mill, router etc)
Hood