Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: awilcox on September 23, 2010, 10:00:13 PM
-
All,
My frustration is at an all time high. >:(
The latest problem centers around my z-axis reversing direction after each push of the jogging key. All was well
a week ago and I was making the final connections of my limit switches and things went south. I had run the break-in program 3-4 times
prior to this setback. I rechecked my connections and all appears to be fine. Has anyone experienced this and if so, what or where can I look to solve this issue.
Adrian
-
You can reverse the axis by going to Config menu then Homing and Limits.
If you still have problems please attach your xml.
Hood
-
Hood,
Thanks for the suggestion. The axis reverses randomly each time you press the +Z or -Z button. I will post the xml this evening.
Adrian
-
Sounds like you have a bad connection on the Z Dir wire or you are getting noise picked up by it.
Hood
-
I did run my power for the router in the same power track. I will unplug the cord and see if it makes a difference.
Good suggestion!
Adrian
-
Good chance that is your problem.
Hood