Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: skanner on September 21, 2010, 08:52:50 AM
-
hi all,
is there a setup in mach to make my x axis go in the opposite direction after installing a new board the y and z are ok but the x is going the opposite way to what it used to,i have checked the wiring to make sure its the same as the others and it is ok its probably just a daft switch somewhere in mach but i just cant find it, or do i have to turn the motor around?
thank you.
john :-[
-
Config menu then Homing and Limits and then change the reverse setting for the axis you wish to reverse.
Hood
-
thank you thank you thank you your a star you have now idea how long i looked at this and just couldn't see it,all the best my friend ;)
-
Ha ha no probs :0
Hood