Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: chuckels on October 24, 2006, 06:12:24 PM
-
Brian,
I did a clean install of V2.0004 and loaded a small part and the leadout is goofy
I reinstalled V2.000 and it is ok-- see picts
any ideas nothing else changed same xml.
chuck
-
Did you check that the IJ mode was not changed. I know you used the same .xml but I saw this happen once a long time ago and I never manually changed the mode.
Hood
-
actually that was the first thing I checked because it burnt me one time before.
thanks Hood
-
Okay,
Art was doing a bit of work on Comp and may have had a bug get in on him :( That is not a good section of code... poor Art!
Please post the section of the file that is the problem.
Thanks
Brian
-
Brian,
here is the whole code -all was created with NS wizards key way and cut rectangle.
thanks,
chuck
-
Hi Guys:
My abject appologies. I was working on another problem and introduced that bug to the code. Redownload, it is fixed.
Art
-
Art,
0005 has the same problem.
chuck
-
Chuck:
Is it .005 from yesterday, or today, I updated in a cuple hours ago with the fix. I just didnt update the version.
I ran your file here and the leadout seems fine. Can you confirm you redownloaded it or did you just check the version
and figured it was the same?
Thanks
Art
-
Art,
todays ver works great, thanks.
while I got your attention why does my mach3mill.xml file get over ridden when I upgrade ever since ver2? it did not do this before Ver2.
chuck