Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: giannis121 on September 08, 2010, 11:57:52 AM
-
Possible while the machine is running a program, to move the Z axis with a button?
I use the mach for cutting with waterjet.
Sometimes i need to move Z axis up or down manualy, while running.
Any ideas?
Thank you.
-
You can set-up THC UP and THC DOWN in Ports n' Pins and assign the inputs to buttons or hotkeys. Works well here in sim.
Russ
-
Thank you for the quick reply.
This will activate just an output.
My Z axis is pulse controlled by mach.
-
OK
I found (after long time) a topic that suits my question.
http://www.machsupport.com/forum/index.php/topic,2656.0.html