Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: JHChoppers on September 01, 2010, 11:31:29 AM
-
Are there OEM LED codes for the higher numbered Outputs? Can't seem to find them anywhere?
Mainly Output20, 19, 18 and 17
Thanks,
JH
-
Not as far as I know. You could use a Brain to set a user LED if you wished.
Hood
-
Bummer.... and thanks hood
-
Hey JH,
Here is a Solution for your issue, the missing I and O LEDs in the upper ranges has been an issue for a long time.
http://www.machsupport.com/forum/index.php/topic,10861.0.html
That is a Plugin that Maps ALL the missing Inputs and Outputs to LEDs, it is the "Standard OEM" Mach Mill screen, but I Modified the Diagnostic screen with the Missing LEDs.
It does this, and uses these resources:
Inputs:
1). OEMTrigger's 1-15
Outputs:
1). OUTPUT's 7-20
2). Charge Pump, Charge Pump2, and Current Hi/Low
ULED's Used for Input Signals are:
1). 1301-15 is used for OEM trigs 1-15
ULED's Used for Output Signals are:
1). 1316-32 is used for Outputs 7-15,Charge Pump,
Charge Pump2 and Current Hi/Low
Also, if your doing alot of R & D, or customizing, look into Mach MAD, it was built for just that........
scott
-
Thanks Scott !
I mapped them to user LEDs and updated my macroPump to read to output states and update the LEDs. But I like this better!
What is Mach MAD ?
JH
-
http://homanndesigns.com/store/index.php?main_page=product_info&cPath=7&products_id=62