Machsupport Forum

Third party software and hardware support forums. => SmoothStepper USB => Topic started by: richyrich212 on August 25, 2010, 10:03:21 PM

Title: smooth stepper and THC300
Post by: richyrich212 on August 25, 2010, 10:03:21 PM

hi all,

I have a working (well almost) plasma table using the smooth stepper and a thc300.    I cant get the z-axis  to make corrections when my thc300 is enabled.  Mach wants to move the z-axis but i get no output.   All other functions of the z-axis work (i.e jog z or, torch touchoff)   

  I posted in the general fourm as was told that the thc300 will not work with the ss

does anyone have a thc300 installed with the ss  that can help ??


thanks

Title: Re: smooth stepper and THC300
Post by: Hood on August 26, 2010, 03:57:57 AM

Replied to you on the General but will do so here as well. THC is not implemented in the SS unfortunately :(

Hood

Title: Re: smooth stepper and THC300
Post by: richyrich212 on August 26, 2010, 12:07:07 PM

okay,  Is there a way that I can use the pc parallel card and the ss  at the same time ??   


i.e   ss to handle port 1   
      pc to handle port 2 

Title: Re: smooth stepper and THC300
Post by: Hood on August 26, 2010, 12:08:41 PM

Afraid not :(
Hood

Title: Re: smooth stepper and THC300
Post by: richyrich212 on August 26, 2010, 07:34:07 PM

hood,

Thanks for all your help !!!!