Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: manmeran on August 25, 2010, 05:45:56 PM

Title: Kflop board
Post by: manmeran on August 25, 2010, 05:45:56 PM

Hi all
i think we have a little information about Kflop and kanalog board.
i hear it is very excellent board, Especially for using servo motor(especially analog servo system)
please share your experiment with other about this board.

Amir

Title: Re: Kflop board
Post by: Flying Scot on August 26, 2010, 02:51:49 AM

Amir,

I recently purchased a Kflop and Kanalog board to drive some Parker Hanifin Analouge drive and servo's with resolver feedback for a router I want to build over the winter.

I have had one axis running in Mach3 on the bench to prove that it will work which it does very well.

There is a group at http://tech.groups.yahoo.com/group/DynoMotion where you will find more information.

Tom at Dynamoton usually answers email questions very promptly and certainly supports his product well.

Regards

Arthur

Title: Re: Kflop board
Post by: manmeran on August 26, 2010, 04:46:18 AM

thx Arthur
I think this thread is a good place to review this product,
Advantages and disadvantages

Amir