Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: arclight on August 12, 2010, 09:28:36 PM
-
I'm trying to work on a post for nestmaster And this is the code I'm coming up with. I get the radius error on the line 16 and I don't understand why. I have IJ set to incremental and distance set to absolute. Nestmaster is set to output incremental IJ and absolute otherwise. I attached the g code any help would be really appreciated
-
I did't get any errors, using 3.42.020
-
hmmm I'm using 3.42.040
I'll see if I can switch versions
-
Hello I think I might have figured this out. When you posting G-code in Lazycam make sure the Incremental IJ's (is not checked) and the G-code didn't have that problem. Thanks ::)
-
Each CAM program has it's owne post processor. I didn't have a problem using 3.042.033 with Absolute and INC IJ modes selected in general config.
RICH