Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: hharley on August 04, 2010, 03:36:30 PM

Title: Display mode/Homeing and soft limits question
Post by: hharley on August 04, 2010, 03:36:30 PM

when i click deplay mode  i can not see the grren patter to my table...when i watch the video it did everything to MM  and i set my homing and soft limites as such..... But then reallized my software set to inches...so i changed it to inches as follows X 16.    Y 24. and Z -4.   came back to display and hit regenerate  and  dis[lay button..............I get a big  green L shape   with item to cut in lower left corner   but not the shape of my table? i have zoom in and out   no change with the L except big and small?

Title: Re: Display mode/Homeing and soft limits question
Post by: Hood on August 04, 2010, 05:33:42 PM

Can you post a screenshot of what you are seeing.
Hood