Machsupport Forum

Mach Discussion => FAQs => Topic started by: neiter13 on July 24, 2010, 02:44:29 PM

Title: Mach 3 help
Post by: neiter13 on July 24, 2010, 02:44:29 PM

I'm trying to make a part and i have all the measurements correct from the original but when i have mach 3 try and cut it, it is 1/32nd off all around. is there a offset within mach 3 that i don't know about. any ideas would be helpful.

- neiter13

Title: Re: Mach 3 help
Post by: ger21 on July 24, 2010, 03:05:28 PM

Not unless your'e using G41/G42 in your code.