Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: sparkyengle on July 22, 2010, 09:31:49 AM

Title: corners have radius at higher cut speed
Post by: sparkyengle on July 22, 2010, 09:31:49 AM

I am having trouble cutting sharp corners at speeds over approx. 10 IPM. If I go faster than that, the corners start to round. If I slow down, it returns to proper cutting. I would cut slower, but it is a pain if I have long strait runs in the same program. I hate having to continuously keep changing my cut speeds. Any help would be appreciated. Thank You!

Title: Re: corners have radius at higher cut speed
Post by: khalid on July 22, 2010, 10:10:28 AM

I think you have CV mode on.. Just go to Config and change CV mode to Exact Stop mode..

Title: Re: corners have radius at higher cut speed
Post by: sparkyengle on July 22, 2010, 10:19:29 AM

That was it! So simple yet has been a pain in my butt for the last year. Thanks So MUCH!!!!