Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: jporter on October 18, 2006, 04:37:55 AM
-
Sorry about asking an elementary question.
I am tring to set up an end mill as tool in tooltable. Which icon do I use for this? The one that looks like a rectangle?
-
Looking through the tooltable I would say it is certainly the only one that would resemble an endmill but really does it matter what icon you use? I could see it being handy for lathe tools as it would give a quick visual identification but for endmills I dont see this being a problem.
Hood
-
Thanks Hood. You answerd my question. I was not sure if the icon had any significance or not. I am also not sure how the diameter wear and height wear parameters are used. The wear is function of time and material used.