Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: Bob La Londe on July 08, 2010, 11:49:08 AM
-
Does anybody have a profile for this machine?
I just picked up one as my seocnd machine, and it came with Windows 98 based control software, but because I have become familiar with Mach 3 I was thinking it might be more convenient if I could run it off Mach 3 so when I generate code files from my CAM software I know they will work pretty much the same on either machine.
Well, that and I don't think I have any 98 machines left even on my spare shelf. I think I have given them all away to a friend reconditions them and gives them away to school kids who's family can't afford a computer for them.
-
Bob,
I presume you have tried the MaxNC mode of operation within Mach - does that need a separate profile ?.
Tweakie.
-
If its any help the pinouts for MaxNC are given on the ftp site.
Hood
-
Didn't know there was a MaxNC mode. As soon as I get a chance I will check it out. Where do I set that mode?
P.S. Does it support open loop machines?
-
Config menu then Ports and Pins and on the first page towards the right you will see the Max NC-10 wave drive option.
Hood
-
Excellent. I will try that as soon as I get it setup.