Machsupport Forum
Third party software and hardware support forums. => Galil => Topic started by: Cncman2nv on July 08, 2010, 11:05:00 AM
-
I would like to know if it is possible for rigid tap using a galil dmc card ?
-
I put the code in there to do it, but it is NOT tested. Try it at your own risk. Maybe with something soft to start with. :)
Steve
-
I like to rigid tap AIR.
It is very forgiving to tooling.
;D ;D ;D
-
Oh, the rigid tapping has to work with a spindle that has an encoder. Do not attempt with just a VFD spindle. Shards of carbon steel will be flying. The spindle is electronically geared to the Z movement, so the setup needs to be tight. But I would think that of any rigid tapping environment.