Machsupport Forum
Support => One on one phone support. => Topic started by: Flyer5 on June 29, 2010, 05:13:10 PM
-
Please call me , Hrs are 7- 5 mon thru fri leisurelinestoves@gmail.com /Mach 3 w mach motion bo board and drives . Thanks Dave
-
????? Are you offering support or requesting it?????
RICH
-
please call me, i am having issues with breaking endmills, the spindle seems to have two speeds no matter what RPM's are in the program if i hit reset it goes slower and i suspect that for some reason this is breaking endmills. with only .035 depth of cut in aluminum (.062 endmill) it bogs the motor down and breaks the EM. yesterday i ran a complete 5x8 plate with no problems and when i loaded the next part it has broken 5 endmills the same way and just a few minutes ago it broke a .032 in carbon fiber!! 713 444 6958 Marcus mantisworx@hotmail.com
-
????? Are you offering support or requesting it?????
RICH
Requesting help .Thanks
-
????? Are you offering support or requesting it?????
RICH
Requesting help .Thanks ????? Are you offering support or requesting it?????
RICH
Requesting help .Thanks
Never mind I found the error of my ways, Thanks ,Dave