Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: ASC on June 28, 2010, 09:18:06 AM
-
Hello, Mach3 newbie here!
I'm just setting up mach on a new 6 axis machine and I am wondering if there is a way to home all axes at the same time, rather than one after another. The machine has 60 x 40 inch table and I'm just looking to speed up the homing process. Any help would be appreciated!
-
no problem - see refCombination in the draft VB manual. http://www.machsupport.com/forum/index.php/topic,12740.0.html (http://www.machsupport.com/forum/index.php/topic,12740.0.html)
-
thank you very much! All axes are now homing and I'm learning all about visual basic and braiiiins!