Machsupport Forum

Third party software and hardware support forums. => Promote and discuss your product => Topic started by: Lee Newman on June 23, 2010, 02:43:57 PM

Title: USB based CNC control pendants from VistaCNC
Post by: Lee Newman on June 23, 2010, 02:43:57 PM
A series of USB based pendants from VistaCNC are available.
Product pictures and manuals are in www.vistacnc.com

--- Plug 'n Play! No USB driver installation. No Mach3 configuration.
--- Work with parallel port output controller and USB based controllers like
SmoothStepper...
--- 100 steps (clicks) per turn MPG.
--- Dedicated control buttons, water proof and dust tight, isolated relay
control loop, ...

Thanks,
Lee Newman
www.vistaCNC.com