Machsupport Forum
Third party software and hardware support forums. => Third party software and hardware support forums. => Topic started by: xaco on June 12, 2010, 07:03:26 AM
-
Hello, i am trying to get a 4th axis toolpath in Mach3. i made a ring in ArtCAM,i made g-code by using few postprocessors(for mach2,mach3mm,model master4th axis rotary...) but none of them made a rotary toolpath in mach...the g-code contains A axis but on toolpath screen its flat or its not anything like it should look.... anyone can help?thank You???
-
Xaco
There are some settings which need to be set in Mach to display the toolpath correctly.
First Mach will only display rotary toolpaths for A axis. Not B or C.
Goto the Toolpath setup menu. Check "A Rotations Enabled" and select the axis which it rotates about.
If the toolpath has Z axis zero at the centre of rotation then the toolpath will display correctly.
If the toolpath has Z axis zero is at some other setting then you must enter the appropriate value in the "Rotation Radius" DRO, which is found on the settings page.
Greg