Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: JDolecki on October 13, 2006, 10:45:28 PM

Title: Breakout board from Bob Cambell Design.
Post by: JDolecki on October 13, 2006, 10:45:28 PM
I put 120v through my board and printer port and Bob Campbell and Jim from Sound Logic replaced it for free even though i smoked the thing, actually burnt traces off the board.(DUH, Hopefully Sony will be that understanding about their laptop.)

Not only is the board top notch they really support their products.

SO BUY YOUR BREAKOUT BOARD FROM THEM!

NUFF SAID!

Here's the e-mail i got from them.
 
I am sending you a new board by USPS priority mail today. See the note from Jim Cullins below.
 
Just send John a new one. I will replace it for him. The other one has all the chip blown and I would not trust it even if I replaced them.
Tell him that because he was honest in admitting what happened it is free from me.
 
Thanks
James Cullins

Robert Colin Campbell
Bob Campbell Designs
www.Campbelldesigns.com
Mach 2/3 breakout boards
Relay boards
Title: Re: Breakout board from Bob Cambell Design.
Post by: Yodawill2000 on October 14, 2006, 08:17:55 AM
Most impressive.