Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: gorantec on May 26, 2010, 05:06:52 AM

Title: have problem with latest version of mach
Post by: gorantec on May 26, 2010, 05:06:52 AM

hi

i instaled latest version of mach and the problem begins what happen machine work and in random time mach3 will stop to work and i need to close the program and start again and then work ?

Are this happen only to me or ?

My Pc work on Windows 7 Pro and i use V Carve Pro for generatin gcode .

Please let me know what can be ?

Title: Re: have problem with latest version of mach
Post by: manmeran on May 26, 2010, 05:10:43 AM

i think you should change operating system to XP

amir

Title: Re: have problem with latest version of mach
Post by: mrpeja on May 26, 2010, 09:24:55 AM

Hi Goran,
 Speak serbian?
Yoy have on Machsupport somewhere instructions how to install Windows XP when you want to use Mach on this computer. I tink this is obvious!
Give up from Win7, XP is the right ting

Title: Re: have problem with latest version of mach
Post by: Jeff_Birt on May 26, 2010, 09:29:43 AM

I use Mach 3 on Win7 almost every day, no problems at all. I do use a SmoothStepper and not the parallel port driver though. If you are using Win7 32bit I think the parallel port driver will work but you have to do the registry modifications, same as for Vista, which are detailed on the downloads page.

Title: Re: have problem with latest version of mach
Post by: manmeran on May 26, 2010, 09:35:51 AM

:)