Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: manmeran on May 10, 2010, 02:23:13 AM

Title: problem by Torch ON and OFF
Post by: manmeran on May 10, 2010, 02:23:13 AM

 hi all
i use mach3 with THC(In addition Sheetcam) for plasma machine.

when i run code(by CycleStart),Z Moves down to trig switch float, and Z=0 and code start, Consider We cut form a Square. now run code.Quarter cut will, and we press key STOP, here X & Y & Z is stop and TORCH IS OFF, now we again press cycle start ,my problem is : code Continues BUT TORCH NOT ACTIVE.

Please guide how the torch is automatically turned When Again the cycle button is pressed.