Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: nickold on May 01, 2010, 04:33:04 AM

Title: Problems with xyz axis needing constant recalibration
Post by: nickold on May 01, 2010, 04:33:04 AM

Can any tell me why I would need to keep calibrating the xyz axis.  Works perfectly for a while and then goes haywire.  Machine is a simple xyz milling machine.  Do I need to license the software to stop this?

Title: Re: Problems with xyz axis needing constant recalibration
Post by: Hood on May 01, 2010, 04:41:28 AM

What do you mean by losing calibration?
Hood

Title: Re: Problems with xyz axis needing constant recalibration
Post by: RICH on May 01, 2010, 07:40:36 PM

Once you have your motor tuning  / configuration done should not need to do anything.
RICH