Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: gmccorkill on April 25, 2010, 07:00:43 AM
-
I am completely new to cnc routing bought a used k2 without a computer have figured out how to manuly move router on x,y,z axis have a program that writes gcode but cant get it to load in Mach any suggestions?
-
Is there an error message?
-
no on my computer in the house(this one ) it will load on th compt hookrd to the machine it wont
-
What happens when you try to load it, how far do you get?
Hood