Machsupport Forum

Mach Discussion => General Mach Discussion => Topic started by: faby on October 08, 2006, 10:49:11 AM

Title: Pause problem
Post by: faby on October 08, 2006, 10:49:11 AM

When mu machine is working and I press the "pause" button (yellow) it stops immediately without a deceleration ramp.
It causes steps loose, a lot.

You can see it here www.fxmodel.it/loose.wmv ... ehm sorry I imitate the bad noise with my voice in the video ehehe.

I tired with 2 different pc, one is a celeron 1ghz the other is a p4 3ghz, in the lastone the "drive test" graph is flat absolutely flat.

Thanks Faby

Title: Re: Pause problem
Post by: Hood on October 08, 2006, 10:54:22 AM

Cant seem to get your link to work :(
Hood

Title: Re: Pause problem
Post by: faby on October 08, 2006, 12:17:23 PM

http://www.fxmodel.it/loose1.wmv

Sorry

Title: Re: Pause problem
Post by: Hood on October 08, 2006, 12:28:40 PM

not sure if it will help but have you tried altering the acceleration a bit in the motor tuning page?
Hood

Title: Re: Pause problem
Post by: faby on October 08, 2006, 12:39:37 PM

Sure... from a very lo value to highest value.

but nothing happen.