Machsupport Forum

Third party software and hardware support forums. => PoKeys => Topic started by: eloid on April 16, 2010, 11:37:01 PM

Title: edge find routine with mach screen sets on a pendant?
Post by: eloid on April 16, 2010, 11:37:01 PM

was looking to make a pendant then i found this thread,
can some please let me know if this possible...

I like to make a pendant with pokey with a lcd and matrix key pad
like to make the keys programable to link with mach screen sets ie

I like to use hoss probing and corner finding fuction and also the pocketing routines
for find diameter of holes etc... and edge finding and z height setting

as seen here http://www.cnczone.com/forums/showthread.php?t=56079&page=16
post 191

http://www.cnczone.com/forums/showthread.php?t=56079&page=15
post 177

is this possible?

Title: Re: edge find routine with mach screen sets on a pendant?
Post by: borisz on April 18, 2010, 06:24:04 AM

Hi!

I did not checked links.
With PoKeys you can sense whatever you want. If you will use plugin, Pokeys is reporting to Mach whatever you set.
With a help of Brains, all is possible.

regards

Boris