Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: kencor1 on April 15, 2010, 05:05:34 PM
-
I tried to update Mach to the latest lock down version. I was using 3.041 and the current Smooth Stepper plugin, everything was working fine. After the update I can jog all of the axis's no problem but when I try to run a program, that ran fine in the old version, will not run right in the new one. Now whenever the z-axis is moving at the same time as the a-axis is rotating everything goes to a crawl. but the z retract and the x move back are fine. I tried changing every setting that I could think of but nothing works. If I run a program that only uses the x,y, and z axis's it works fine. Does anyone have any idea on what is going on? For now I will just go back to the old version.
Tom