Machsupport Forum

Third party software and hardware support forums. => LazyTurn => Topic started by: Ampliflyer on April 09, 2010, 09:08:51 PM

Title: open gl error?
Post by: Ampliflyer on April 09, 2010, 09:08:51 PM

I am so lost...been learning autocad,,,, I draw in inches , I draw in the -x,y quadrant , I save as DXF12, but when I try to import into lazyturn I get this ugly "open gl error" then a black screen.

I'm following the tips to the t I think ?  what is going wrong?

Title: Re: open gl error?
Post by: RICH on April 10, 2010, 07:50:20 AM

Post the DXF file and i will have a look at it. See attached as it nay have nothing to do with what you are drawing.
RICH