Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: jeeplogic on April 09, 2010, 10:34:07 AM
-
When I am in the run program, MDI, Tool Path and settings screen the DRO is correct for the appropriate axis. (x=x, y=y, z=z) In the diagnostic screen movement in X axis shows up show up as movement in the A axis DRO is this a glitch or is there a place to assign axis in the diagnostic screen only.
Thanks for helping
Greg
-
It sounds like it may be a screen problem, are you using the standard screen?
Hood
-
no I am using plug-ins from CandCNC for custom screens. Don't know why that would make a difference.
-
The screenset is likely to have the wrong oem code assigned to the DRO, if you either tell me where to download the screenset or attach it here I will have a look.
Hood
-
here is the screen set I am currently using thanks for looking
-
Try loading this one, they had X DRO as C and A DRO as X.
Hood
-
Thank you that works perfectly
-
No problem :)
Hood
-
Hood I may have spoke to soon, I first loaded it in my test mach 3 on my lap top. When I loaded on the control computer in the shop I noticed that the velocity still shows up in A but the DRO displays in X correctly. thank you so much for your help.
-
Just to be clear, you are seeing the Velocity in the A DRO? by Velocity are you meaning feedrate? And this is on the Diagnostics page?
Hood
-
Just to be clear, you are seeing the Velocity in the A DRO? by Velocity are you meaning feedrate? And this is on the Diagnostics page?
yes, the feed rate for the x is showing up in a, but only in the diagnostic screen
-
Ah Ok I see that there are Velocity DROs on that screenset. I only changed the position DROs, hang on a few mins and I will look and correct the Velocity ones.
Hood
-
OK try this.
Hood
-
Thanks hood.
Today is the first day I have not been working since my last post I loaded it up and worked like a charm.
Greg