Machsupport Forum
Third party software and hardware support forums. => LazyTurn => Topic started by: Ampliflyer on April 06, 2010, 11:10:58 AM
-
Me again...sometimes when I import a DXF r12 I get to change the rulers to the correct diameter of stock but my profile diameter is way too big and it has a minimum that is larger than my set stock diameter?
I have been all thru the manual but still cant figure it out?
-
What LR imports is what you have drawn. If you drawing represents a diameter then in the OPtions menu ( section 5.3 ) you should select diameter mode. Same goes for imperial or metric mode. You can change the stock diameter if you wish with the the penatgons ( see section 6.2.1)
RICH