Machsupport Forum
Mach Discussion => General Mach Discussion => Topic started by: giordano on January 17, 2006, 09:20:57 AM
-
Hi to all. I have found a serial card of interface in the site
www.cncitalia.net realized through a microcontroller PIC18F452. Could Mach3 pilot a serial card and like? Thanks, Giordano.
-
IF it is to get a comport on your computer I think so... I can't read the page :(
Sorry
-
IF it is to get a comport on your computer I think so... I can't read the page :(
Sorry
I apologize. The site is this http://www.iprocam.com /
-
I See!! I don't know if the Cam from this will work in Mach 3... This software can run a machine and has Cam built in so I think it is going to make code for it's self.
There could be others out there that have used it in the past.