Machsupport Forum
Third party software and hardware support forums. => LazyTurn => Topic started by: whatda? on April 03, 2010, 03:23:36 AM
-
Hi to all,
Just curious how we go about setting the home position with Lasyturn
and also how do we machine a simple profile without the tool going to
x0 and cutting of the stock at the end.
I have enclosed a picture of what I mean.
Tried so many things which didnt work.
So far excellent addon, simple and easy ! ;D
Any thoughts,
Thanks
Regards
Whatda?
-
WHATDA,
Attached is a rough draft of Appendix "F" of the LazyTurn Manual which should answer most questions and then some.
You can't print the document but you can read it.
RICH
-
Hay Whatda
Could you attach the dxf and the *.tap file
Greetings:
Willem